Spliiter end plates

The splitter is not allowed to extend beyond the bodywork so to make it more effective, an end plate is added to keep air from spilling over the side of the splitter.

I started with making a template out of construction paper

Then transfered the shape to aluminum and cut it out with the plasma cutter

With a tab bent under and behind the endplate, I could rivet it to the splitter and bolt it to the spoiler for easy removal

Exhaust shield

I am concerned about heat from the exhaust discoloring or bubbling the paint so I decided to build shields. I started by cutting a template out of construction paper

Then transfered the shape to stainless steel. I am using stainless because it gets a cool pattern when it gets really hot

I cut out the pattern with the plasma cutter

Then gave it a quick sanding with 320 grit paper

I'm not sure the stainless will ever get hot enough to discolor but I like the look so I helped it along a little

Then riveted it on

Looks cool, right?

Intake manifolds modification

The aluminum block on the left needs to be attached to the intake on the right

This beautiful piece took 18 hours of computer modeling and a bunch more time on a CNC mill

This is how it will be mounted with the carb

JRS manufacturing http://www.jrstephenson.com/ did a great job welding billet aluminum to cast aluminum. It's very difficult to join these two materials together without cracking the cast aluminum but somehow they did it.

I used a die grinder to clean off the seam left over from the casting process

And I tapped and plugged the air injection ports

The centre still needed to be opened up

Which I did with a hole saw and die grinder

After a coat of paint, they look pretty good

I was much relieved to find that the hood will close without being modified

Mesh Grille modification

Here is the stock grille with it's vertical bars. Also note the splitter struts

The grille in it's stock form

The vertical bars are a pressed aluminum piece helded on by rivets

Here it is removed from the grille housing

Once the bars were out, I used the plasma cutter to zip them all off and use what's left as a surround for the mesh

The mesh was riveted to the grille and bolted back on the car. The bumper isn't installed yet.

I also riveted mesh into the cowl vent

Reassembly-splitter, spoiler, fenders

I took some aluminum channel and drilled holes in it

Then cut it into pieces

Cleaned them up a little by buffing the edges

And voila', a mount for the spoiler bracket is made, ready to rivet on.

I bolted the wheels and fenders on

Reassembly-Seats, shifter and interior panels

The seats and belts are in-it's a tight fit.

The fuel filler hoses are on, fuel line plumbed and panels riveted in.

Rear spoiler is on. I had to trim it in a few places to keep it from scratching the paint.

The shifter is on and the 11 holes I drilled in the rod brings the total number of lightening holes drilled in the car to 429!

Reassembly-heat shield, radiator and taillights

I was concerned about heat from the sidepipes bubbling the paint on my door sills and doing bad things to the silicone I sealed the aluminum plates on with so I got Hushmat heat reflective tiles from wwwfasttoys.net and glued them on where the sidepipes go. The adhesive on the tiles is rated for 400 degress, hope that's enough.

I cut a bunch of holes in my top radiator mount and bolted the rad in.

I took some aluminum mesh and riveted it in the opening where the taillights used to be. I went through the trouble of making aluminum trim rings but it looks racier and better without them. Air in the rear wheelwells will have an easy exit out these vents.